Beijing GlobalIPL Development Co., Ltd.
Good quality proved over the time, Good service depends on the behavior
Add to Cart
Medical Co2 fractional laser machine
I. Theory
This technology is known as Fractional Photothermolysis theory (dot-matrix light and heat decomposition), the 10.6μm far-infrared laser will evenly mark with tiny holes, and then cause a series biochemical reactions inside the skin, thus to reach the results of skin lifting & resurfacing, pigments and scar removal, etc, finally let the skin return to young again.
II. Applications:
III. Features:
1.USA Coherent RF laser emitter
1) even output energy, deeper penetration(8-10mm under the skin)
2) long lifetime:5-10 years
3) smaller sopt size:0.05mm at dia
2.Imported excellent 7 articular optical-arm,easy operated and greatly reduces the energy loss;
3.6scan modes:sequence, random, maximum distance A&B, Equidistance and fast shot;
4.7 scan shapes:square, rectangle, round, triangle, oval, 6-diamond shape and line
5. Ultra-quiet pump used, lower noise but larger water flow;
6. 3in 1 system,easy and convenient for operation.
1) Fractional CO2 Laser for skin rejuvenation and scar removal
2) and Normal CO2 laser for surgery operation
3) Vaginal tightening for option.
IV. Parameters:
Basic specification | |
Wavelength | 10.6μm, far-infrared laser |
Control | LCD 8.4 inch |
Pulse frequency | 33.3 Hz |
Duration | 0.1~10 ms |
Distance | 0.1~2.6 mm |
Interval | 0~6s |
Repeat | 1~5000ms |
overlap | 1~20 times |
Average power | 40W |
Working mode: | Continuous pulse, single pulse, interval pulse |
Scan Graphics | Square, rectangle, round, triangle, oval, 6-diamond shape, line |
Dot quantity | 400 dots at most |
Working state | Hyper-pulsed mode |
Scan mode | Sequence scan, Random scan, Maximum distance A&B, Equidistance, Fast shot. |
Pulse energy | 10mj to 130mj is optional for each dot. |
Technical specification | |
Condenser focus | f=50mm |
Beam divergence angle | 0.3 mrad |
Spot size | 0.05 mm |
Aiming beam | Less than 2mW, 635nm red semiconductor laser |
Cooling system | air cooling |
Environment temperature | 5-400C |
Relative humidity | ＜80% |
Temperature in transit | -40-500C |
Humidity in transit | ＜85% |
Beam transport device | Articulated arm with 7-joint and balance weight |
Atmospheric pressure | 86.0kpa-106.0kpa |
Warming up time | 2 min |
Electromagnetic requirement | No electromagnetic |
Field interference | |
N. weight (kg) | 42kg |
Power supply | 220V/110V |